Author: M. Feld

Inline Paint Chamfer Detection

imess offers an inline inspection module for the wood industry which detects incomplete paint on wooden boards and signalises that via customer interface to controls. The 100% inspection is conducted inline and works with a line scan camera for each wood board edge. High quality wood boards are chamfered during production. Apart from the significant…

Inspection of In-Mould-Labeling (IML)

In the in-mould-labeling process, the label is already in the mould of the final product. Only the liquid plastic has to be filled into these, thus temperature and humidity resistant labels can be produced in a short production time. Another advantage is the lower material usage with the same stability. The technique is preferably used…

By M. Feld Thursday December 17th, 2020

3D Valve Spring Geometry under Load

During daily operation, springs have to stand high pressure. It is essential to be within format since the compression changes the pitch of the spring crucially. In order to check the format – the geometry under load – imess developed the system F435 CL. The basic construction corresponds to the established system imess F435 to…

SpringBy M. Feld Friday November 27th, 2020

Comprehensive Inspection of Stabilizers

The stabilizer spring belongs to the most important safety components of vehicles. Thanks to this intelligent connection between the wheels, the roll angle is reduced and the ride characteristics are stabilized. In order to ensure high driving security, a geometry inspection of the stabilizers is vital. The optical imess inspection system F300 controls the stabilizer…

SpringBy M. Feld Tuesday November 3rd, 2020

Inline Optical Inspection Systems

Inspection modules are integrated inline to observe the production 100%. The optical inspection systems can easily be integrated any time – even after line construction – due to their sparce space requirement. Depending on the production environment, camera laser and possibly a backlight are used. The evaluation of the collected data and their immediate transfer…

By M. Feld Friday August 28th, 2020

Optical Height Check of Wave Springs

Wave springs are used in the industry mostly in limited installation spaces. The height of the spring is up to 50% lower compared to valve springs with similar power. Characteristics The critical production settings of the components can be checked with the compact system solution of the imess F920 fast and uncomplicated. The system offers…

SpringBy M. Feld Thursday July 9th, 2020

Record and check the 3D Geometry of Suspension Springs

The imess F880 system has been designed to check the 3D geometry of of suspension springs up to 600 mm contactless and thus fast. Prior to measurement start, the spring is placed onto a centralising bolt and fixed in an upright position with two cones to ensure the best possible measurement results. Pitch Gap Diameter…

SpringBy M. Feld Friday June 19th, 2020

digital measurement of coil set

The latest development imess S30 detects the coil set of metal digitally and operator independent. The coil set phenomenon is typically occurring during decoiling processes due to the tension of the material itself. If the coil set is undetected, severe problems occur during the stamping. Regular inspection is thus required. The sheet sample is manually…

MetalBy M. Feld Monday May 25th, 2020

Detect Burr of Sheet Samples reliably

Cutting or stamping metal leads to burrs at the material. The burr may cause a bad final product. Therefore, the aim has to be the prevention of these burrs as early in the process as possible. Its development has to be detected as well as its height. The capable measurement system imess S28 is equipped…

MetalBy M. Feld Friday March 13th, 2020

Exhibition impressions

Messse ImpressionenBy M. Feld Friday March 13th, 2020

Author Archives: M. Feld